Shutdown of IPO With UC Module

[config5623]

Hi all,

My 500v2 control unit is ver 9.1.1. Should I shutdown the UC before shutdown of control unit?

Extensions on BD2 have static and can not access secondary dial tone after pressing 9. This began after a thunderstorm. I was going to try shutdown first before replacing digital card in BD2.

Thanks

 

[Westi]

yes, definitely shut down the UCM first. I had 2 die on me when power was just removed.

Joe W.

FHandw, ACSS (SME)


"This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter

 

[IPGuru]

Issuing a shutdown command from the Manager application (to perform a polite shutdown) should correctly shutdown the UCM in the process.

As west has stated do not simply remove power

This began after a thunderstorm.

If you think the system ha been damaged in a thunderstorm it would be wiser to replace the whole system, you cannot be sure that no other components have not been damaged/weakened & are likely to fail shortly because of this.

Now is the time to have it all replaced whilst it can all be placed on the same insurance claim.






Do things on the cheap & it will cost you dear