Show configuration command on Cisco C2950G-48-EI

[brimar]

When i type de command "show conf" on my new switch i see on all FastEthernet interface "no ip address" and on my all other switch i don't see this line.

Are there a verbose mode on the "show" command ?

Thank you
Martin Briand

 

[computerhighguy]

That happens. Upgrade to the latest IOS image and it goes away.


It is what it is!!
__________________________________
A+, Net+, I-Net+, Certified Web Master, MCP, MCSA, MCSE, CCNA, CCDA, and few others (I got bored one day)

 

[lui3]

sounds like an IOS version thing. in the later IOS s the code adds the port trunk state

desirable to the each interface in show run. this is the normal state but is not explicitly defined in older IOS versions. New ones put the line in for information.