Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ShoreTel (T1K) TIE to R11 NEC 2400 (24DTR)

Status
Not open for further replies.

PBXDocJeff

Vendor
Aug 20, 2010
7
US
Any of you ShoreTel guys done a plain T1 TIE to an NEC 2400? - would love to hear your settings - posted this earlier to the NEC page as well - any insight would be greatly appreciated!

Calling on the old NEC heads!!! Well, about 10 years and 3 laptops later I need to remember how to set up a plain T1 tie (24DTR to an SGT1K) for 4 digit dialing between an R11 NEC 2400 and a ShoreTel - nothing fancy, no caller ID - just simply 4 digit dialing - I'm mainly looking for the DPSW and ARTD - I've tried quite a few settings and while the channels will idle up the ShoreTel side will hunt channels w/ dead air when accessed (I can see it hitting the channels on the 2400 too)- the NEC gets a "rest" in the display - I'm sure it's signaling. I unfortunately dont have a spare PRI card for the NEC - I know that would be the better route (No pun intended) - Any assistance would be GREATLY appreciated!

Jeff
 
To PBXDofJeff,

I too would be interesting in seeing the configuration end for the NEC to a ShoreTel. Just happened upon a project to tie a NEC 2400 IPS to my ShoreTel. I know someone has had to of done this...

SHK Certified
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top