Setup X-lire / BRIA on iphone

[Jakt99]

This is doing my head in......

Have setup a sip extension on 3300 and working and tested with V3 app on notebook fine.

have downloaded bria on iphone and connecting iphone via local wireless connection to 3300. At this stage wireless connectivity is a test AP with no security enable, dhcp provided by 3300.

The iphone connects to wireless AP and gets IP address fine from 3300.

Have configured BRIA with domain (3300 IP), user and password (same as notebook) and everytime I try connecting to mitel I get message on iphone barring connection "forbidden error 403" which indicates a bad password if I remember correctly.....The 3300 logs indicate iphone trying to connect to 3300 as well....

Have tried resetting password in 3300 sip extension and iphone many times and yes the notebook extension is dsconnected from 3300. Have even created a new sip extension on the controller get same result.

Something to do with iphone me thinks but..........


Details
3300 CX MCD 4.2
Iphone 3gs
BRIA for iphone, V1.2.10 build 6306

 

[SXWizard]

I am using Bria on an iPad with no problems. I have a customer using Bria on an iPhone with no problems. That said let's check settings for Bria first.

In the account
Display as = 2188
Username = 2188
Password = 2188
Domain = example.com

Account Advanced
Out Proxy = IP address of 3300:5060
Auth Name = blank (default)
Send DTMF using RFC 2833
Global IP = off
Use Tel Uri = off
SIP Transport = UDP
Encrypt Audio = Never
Incoming calls = On
Single Register = off
Refresh Interval = 900
WiFi Interval = 30

Advanced Settings
Current Strategy = Server Managed
Use VPN if Active = off
Voice Activity Detection = off
Noise Reduction TX = on
Noise Reduction Rx = off
Quality of Service = off
Verify TLS Cert = off
Support RPort = on
Support PRACK = off

In the 3300 use the same username and password as Bria is using.

 

[Jakt99]

Thanks for a complete detailed config of iphone SXWizard,
will review, and let you know where I have gone wrong.

I have set up many different SIP devices on a 3300 before, some easier than others, but this Grrrr???

Usually I don't have issue will registering, its always been with SIP device capability integration and tinkering with the associated form on the 3300.

 

[SXWizard]

If these setting on Bria don't help I can post the 3300 SIP device settings. I think I just used the default...

 

[LoopyLou]

Have Bria working on PC, iPad, iTouch and Samsung Nexus S ( Android ) with no issues.

Test SXWizards suggestions because it should work ok as long as there is routing from your wireless network to the voice.

The single biggest problem with communications is the illusion that it has taken place.

 

[Jakt99]

SXWiard

No need to post 3300 SIP settings. I used defaults with the PC version and that work fine. Well crudely speaking anyway, until checking through all the features and timers etc.

And

LoopLou

Thanks also, and good point. I forgot to mention earlier that I tested the PC version via the wireless AP as well, prior to using Iphone version, plus accessed the ICP web interface too, so the back end networking / routing is fine.

 

[LoopyLou]

think I needed this to get the iTouch working.

Advanced SettingsCurrent Strategy = Server Managed

The single biggest problem with communications is the illusion that it has taken place.