Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
setup modem for remote access for Merlin Magix
- Thread starter TMW1
- Start date
TouchToneTommy
Vendor
The modem is built in. It is extension *10
The default remote access code is 889
You have a block of DID numbers, pick one of them to be your remote access number
Under System Renumber, Single, Remote Access, change the default number to the DID number.
Under Lines, Remote Access, Code Info, Code Entry, create a Barrier Code to prevent unauthorized users from getting in.
Also under Remote Access, under System Programming, assign the barrier code for programming access.
Now dial the DID number, it will ring two times and answer with a stutter dial tone. Dial the barrier code, it will return dial tone again, then dial *10 to be transferred to the modem.
The default remote access code is 889
You have a block of DID numbers, pick one of them to be your remote access number
Under System Renumber, Single, Remote Access, change the default number to the DID number.
Under Lines, Remote Access, Code Info, Code Entry, create a Barrier Code to prevent unauthorized users from getting in.
Also under Remote Access, under System Programming, assign the barrier code for programming access.
Now dial the DID number, it will ring two times and answer with a stutter dial tone. Dial the barrier code, it will return dial tone again, then dial *10 to be transferred to the modem.
- Status
Similar threads
- Locked
- Question
- Locked
- Question