Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Setup a fax line
- Thread starter rburcham
- Start date
ATA used with Fax Machine:
-You need to set ATA DN to Hotline. Hotline selects whether a telephone will be dialed automatically when receiver is lifted. Programmed in capabilities under terminal and sets.
-Scenario: A customer has a Norstar® MICS 4.1 system. This customer has a fax machine attached to the MICS via an ATA. When faxing out of the system they use a line access code of 9 and then the desired recipient telephone number. They want to simply dial the number without dialing the access code when faxing.
-Solution:
1. Under Services, build a Route and point it to a Pool Group. Then build a Destination Code and point it to the Route.
2. Under Terminals & Sets/Line Access change PRIME LINE: NONE to INTERCOM for the analog station.
3. Under Terminals & Sets/Capabilities change HOTLINE: __ to be EXTERNAL, then HOTLINE DIGITS DIALED OUT: to be the Destination Code in step 1 and then change the USE LINE: __ to be USE ROUTING TABLE.
4. Give the station in question Line Pool Access to the Pool Group in step 1.
Good Luck!!
-You need to set ATA DN to Hotline. Hotline selects whether a telephone will be dialed automatically when receiver is lifted. Programmed in capabilities under terminal and sets.
-Scenario: A customer has a Norstar® MICS 4.1 system. This customer has a fax machine attached to the MICS via an ATA. When faxing out of the system they use a line access code of 9 and then the desired recipient telephone number. They want to simply dial the number without dialing the access code when faxing.
-Solution:
1. Under Services, build a Route and point it to a Pool Group. Then build a Destination Code and point it to the Route.
2. Under Terminals & Sets/Line Access change PRIME LINE: NONE to INTERCOM for the analog station.
3. Under Terminals & Sets/Capabilities change HOTLINE: __ to be EXTERNAL, then HOTLINE DIGITS DIALED OUT: to be the Destination Code in step 1 and then change the USE LINE: __ to be USE ROUTING TABLE.
4. Give the station in question Line Pool Access to the Pool Group in step 1.
Good Luck!!
curlycord
Programmer
I used to setup the ATA primed to pool A and under external hotline I would use Feature78....does this way still work also for those who do not have routing tables?
- Status
Similar threads
- Locked
- Question