Settup two Operator Nec SV8300

[aastra33]

Hello All Support, me need help me settup and config system pabx nec sv8300

I have System pabx nec sv8300 have config operator to Business ConneCT (BCT)
and now want config and operator DT330 12Key+ DSS 60key
- I want to configure two operator. ext: 5108 and 5109
- I have ISDN E1 30b+D when outside calls to ring operator ext 5108 or 5109
- internal call dial 0 to operator ext 5108 or 5109
- outside call dial 9
wait help config settup operator

 

[belevedere]

Assign 0 as a single digit extension number. Build a virtual extension as number 0. Place 0 as a button appearance on both extensions.
EX: CMD's
200>0>801
11>0000>0
9000>5108,01>0
9000>5109,01>0

 

[aastra33]

Thanks belevedere for support.

now i want pabx system sv8300 not connect Business ConneCT (BCT).
and outside calls to ring operator 5108 and 5109 ? what config cmd?

 

[belevedere]

Not sure what you want to do, but to direct outside calls straight to a specific extension (0), use the DIT assignment in 3002/3003 set to 04, and 3004/3005 set to 0
EX: CMD
3002>TK Number>04 - sets day mode trunking to DIT
3003>TK Number>04 - sets night mode trunking to DIT
3004>TK Number>0 - sets trunk to terminate on extension 0 for day mode
3005>TK Number>0 - sets trunk to terminate on extension 0 for night mode
Do this for all of your trunks. Does not apply for PRI/ISDN/SIP or T-1 trunks

 

[aastra33]

Hi belevedere.

I user Trunk E1. and 8 line analog backup ,when E1 die trunk analog run,

 

[belevedere]

What digits are being pulsed in from Telco?