Setting up PBX with IP interface?

[chipig]

We have 3 PBX in our system and one of them has no ethernet connector.I use the com port to program it but I wanna be able to access it via telnet like the others.
The PBX is an IVS 2000 with a CP26-A card in slot AP7.

Can I just add a PZ-M606-A card on top of it to get an IP interface?

What king of programmation is needed in order to do this?

Here is my firmware version:
SC-3385 K1-0003.00

 

[belevedere]

Yes,you can. You need to program CMD's
0B00>00 = System IP address
0B00>01 = System SNM
0B00>02 = System Gateway if required.
EC6>0>0 to back it up to the flash ROM, then you need to reset the system.
You can do the programming then back up the flash, then power down to install the M606 ether card.

 

[chipig]

Thanx a lot!
All I have to do now is find the ether card.