Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Setting up NIM for different networks

Status
Not open for further replies.

trifo

MIS
May 9, 2002
269
HU
oHi,

I am struggling setting up a NIM master to serve hosts on a network that is not directly accessible through the "master"-s default interface. I now that I need to set up network definitions and maybe NIM routes, but got confused.

The master has 2 interfaces:
* en0 holding the address which is belonging to its hostname, therefore the AIX default gateway is using that interface (let's call this Network-master1)
* en1 holding IP address from another network. Hosts from this network are enabled to communicate with hosts from my target network, but that communication needs a static route to be set up in the OS - as the default gw routes in a wrong direction. (Let's cal this Network-master2)

And there is another network, holding the to-be-clients - Let's call this Network-client

Every object is served from the master. If I understand correctly, I only need NIM routes is some objects are served from different nodes, thus I would not need this. Is that right?

I tried to set up a second install interface for the master, but as it is part of Network-master2 and not Network-client, I was unable to make NIM to set bootp server address to its second interface IP. It always put "sa=IP.ON.FIRST.INTERFACE" and therefore the client is unable to get its boot package.

Now I am stuck. Can you please help me?

Best regards,
--Trifo

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top