Setting up key module on cme

[glennmitel]

hello

i am trying to program a pkm or key module on to a cisco call manager phone.

the unit is connected and has just lights on it but i cannot find where to program the unit it self and assign the keys with numbers or features.


thanks


Glenn
CCNA

 

[jpm121]

Are you talking about the 7914 attendant console (a.k.a sidecar)?

 

[glennmitel]

hello


yes i am i forgot to put the 7914 bit on the post

thanks.

 

[jpm121]

glenn, did you get this set up? I can post a config if you need it. Sorry for the delay, been out of the office.

 

[glennmitel]

hello mate no i did not get this work if you could let me know the config that would be great.


thanks

 

[jpm121]

Okay, you need to be sure you're set up to handle the attendant console - set up your router to tftp the config file for the 7914, available from Cisco's site (depends on what version of CME you have). For me it is:

tftp-server flash:S00103020002.bin

Then you need:

telephone-service
load 7914 S00103020002

After than make sure the ephone entry knows there is a 7914 attached:

ephone 7
username "b****" password 2604
mac-address 000D.BC50.XZZZ
type 7960 addon 1 7914
button 1:83 2:84 3:85 4:86 5:87 6:7 7m12 8m14
button 9m15 10m16 11m17 12m21 13m25 14m24 15m22 16m20
button 17m26 18m23 19m29

The "addon" keyword tells it you have a single 7914 console. The button lines tell what to do with the buttons, in my case they are all Monitor buttons for various ephone-dn's we use. Could also be speeddials or whatever.

Reset the phone and the console should come to life a few seconds after the phone does.

If it doesn't work chances are you have a tftp issue - turn on debug for tftp and see what you can see.

Good luck, and let me know if you need more help.