nightwolf91
Technical User
Hi,
I am hoping someone can point me in the right direction on setting up DISA on a UCP600.
I would like a caller to be able to phone a specific DID and have the UCP600 return dial tone so that the caller can dial '9' and use the UCP600 outgoing trunks.
I have enabled disa in CO Line Data > Common attributes. I have tried setting 'DISA Service Attributes' in Pgm 146 to 201:Only Tone Mode and in Pgm 167 'DID/DISA Destination' I have set the options to 'Tone'. I have tried setting up a ICLID Table and CCR index but no luck. I can't seem to get the DID to answer and return a tone instead of ringing to a station or CCR.
Any help with this would be appreciated.
Thanks,
nightwolf
I am hoping someone can point me in the right direction on setting up DISA on a UCP600.
I would like a caller to be able to phone a specific DID and have the UCP600 return dial tone so that the caller can dial '9' and use the UCP600 outgoing trunks.
I have enabled disa in CO Line Data > Common attributes. I have tried setting 'DISA Service Attributes' in Pgm 146 to 201:Only Tone Mode and in Pgm 167 'DID/DISA Destination' I have set the options to 'Tone'. I have tried setting up a ICLID Table and CCR index but no luck. I can't seem to get the DID to answer and return a tone instead of ringing to a station or CCR.
Any help with this would be appreciated.
Thanks,
nightwolf