Phonemanrwj
Technical User
I have programmed the TN2198 in my CM 3.0 8710 switch.
I gave each BRI extension a SPID #,
since we are looking to use this for video conferencing.
Currently I have set up 4 ports with 2 end points on each port.
When I test the board it fails test 621 with an error code 1. Each port is failing test 626 with error code 1113.
Can I test this without an isdn phone or equipment to set up at this time?
The PRI-ISDN T1 the calls will be routed through is Verizon
will this present any issues for me?
Any assistance is appreciated.
I gave each BRI extension a SPID #,
since we are looking to use this for video conferencing.
Currently I have set up 4 ports with 2 end points on each port.
When I test the board it fails test 621 with an error code 1. Each port is failing test 626 with error code 1113.
Can I test this without an isdn phone or equipment to set up at this time?
The PRI-ISDN T1 the calls will be routed through is Verizon
will this present any issues for me?
Any assistance is appreciated.