Setting Up An 8400B as a system ptinter port.

[ttech]

I Am trying to set up an 8400B data module for a system printer. I currently have S24 set as 247. It seems to connect but all it prints is jibberish. Any help would be appreciated

Don

 

[clausen]

One of the tricks to setup the data module is the s24 register. This will allow the data mod to be used without a telephone. Use the ats24=1 to do this(this will solicite a ton of discussion here!). Set it for auto-answer (s0 REGISTER), it will only remember the last baud rate, parity, and stop bits you set it up with, so I recommend settign the data module to the specific settings you have for your printer.

Here is a link to the Avaya site to set the system parameters:

http://support.avaya.com/comsys/definity/g3/pa/1617.jhtml

Chris