Setting PRI protocol on BCM 450 R5 1

[TnPhoneguy]

I have installed a PRI mbm in slot 1 of the main cabinet.Under config/tele resources it shows up as DTM-PRI lines 001-023. I cant find where to set the protocols for the PRI.
Thanks

 

[cook1082]

If you click on the PRI in resources it will show up in the window below.

 

[TnPhoneguy]

I moved deconfigured the card and moved it to slot 4 in the main cabinet and reconfigured it for DTM-PRI. When i click on the MBM line a box flashes and retriveing data then i wait and nothing shows up in the bottom part of the screen. How long should i have to wait?
Thanks

 

[snowman50]

Old version of element manager such as version 60---- dont show all screens properly and can cause this.

If you are working on a bcm450 r5 then make sure you run the element manager from the application launcher.
This is a newer version 61---

This will allow you to see the correct screens and open them up

 

[TnPhoneguy]

Thanks snowman50,
Upgraded the BEM i was using and works fine