Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Setting NIC (100\10Mbit, Full\Half Duplex)
- Thread starter Mortifer
- Start date
If you go into INETCFG, you should be able to select the NIC card and set the settings to:
Speed = 2 100 meg full duplex
Duplex = 1 (Full Duplex)
You should be able to double check this against the vendor documentation.
HTH
Mark C. Greenwood, CNE
m_jgreenwood@yahoo.com
CNE 4.11 and CNE 5 certified. BS Degree in MIS. Working in the industry for 8 years.
I work with NT servers, NDS for NT as well.
Speed = 2 100 meg full duplex
Duplex = 1 (Full Duplex)
You should be able to double check this against the vendor documentation.
HTH
Mark C. Greenwood, CNE
m_jgreenwood@yahoo.com
CNE 4.11 and CNE 5 certified. BS Degree in MIS. Working in the industry for 8 years.
I work with NT servers, NDS for NT as well.
BrownlowDown
IS-IT--Management
Is this a 3com Card?
These Cards may need to be set in DOS. Depending on which card it is, I have found that you may need to use the 3com config utility to set the connection properties. If INETCFG works then use that however!
These Cards may need to be set in DOS. Depending on which card it is, I have found that you may need to use the 3com config utility to set the connection properties. If INETCFG works then use that however!
- Status
Similar threads
- Locked
- Question