Setting Incoming and Outgoing Lines on a KXTD-1232

[RoundAbout]

How does one go about setting up specific lines as INCOMING ONLY?

How does one setup the line preference for OUTGOING calls?
We are using a 9 to get an outside line but I don't know where to change the PRIORITY of the outgoing lines...

Thanks!

RoundAbout

 

[mrpeabody]

See this thread:

thread936-577024

 

[Hitechbuzz]

Hi Roundabout
If you use command 400 and use No connect it will only take i/c calls or if you put it into a line group by itself and don't assign the line group in Cmd 103 I think that would work as well.
Cheers Brian