Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

set locked during a firmware upgrade

Status
Not open for further replies.

eastcoast10

Technical User
Apr 11, 2011
38
CA
I was upgrading the firmware on a 3905 set and although told not to do so the agent put the set in make busy while it was downloading firmware.

The phone indicates that it is awaiting download. If you put a new phone on the TN it doesn't fully come up, the DNs and the feature keys don't come in. If you go into load 32 and look at the status of the set it says MKBSY.

I can not get it out of that state. I am hoping that the nightly routing will clear the status of the port so I can use the TN again.

However any suggestions on how to
reactivate the port
reactivate the phone
would be appreciated.
 
Try the following

Trying to do CHG on M3904 TNB get SCH1958 : TN is blocked since midnight download is triggered for the Taurus set type.
Tried to DISU TNB got NPR034 : DISU command is blocked because the unit being disabled is experiencing
a flash download.
Tried FDLU TNB said already had latest Firmware.
FDLF TNB and now able to CHG or DISU OK

#############################################################

Details:
Unable to access any overlays on call server, OVL306 given on TTY. This was the result of a failed FDLU to an M3903 telset in my case, I suspect pertinent to all M3900 range of phones however.
After accessing load 32 by using the suspension command and an FWVU is run against the affected TN you get 'PSDL IS NOT IDLE' message
Fix:
Use the suspend command to access ld 32, use fdlc to cancel the suspended command, disable & enable the affected card and re-commence a subseqent FDLU.
This time, in my case, the download was successful.

OVL0306 This Overlay can not be active during Peripheral Software Download (PSDL).
Action: 1. Wait until PSDL is complete.
2. Use the SUSP command to suspend the PSDL and load the required program
(LD xx SUSP). Use SUSP with caution.
You may have to LD32 again after using the SUSP command to gain full access

#########################################################

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

If it's working, then leave it alone!.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top