Service Status overview of all stations

[TheWOneAndOnly]

Hi

I'm lookoing for a way to get an overview of the "service state" of all our stations (like you see with the command "status station xxx")
I want to do this to fond obsolete stations so I can free some ports

Any idea how to do this?
I really don't want to type in the command "Status Station" for 1200 stations.

I'm using DSA R1.8.03

thx in advance

 

[1a22ip]

When I am looking for ports as well as numbers I use the list errors command. The error code 513 means no set on the end of the cable. I then run a Call accounting report to see when the last call was made. I luck out because the telephone extensions are managed by another department. Someone leaves, the phone is moved and the extensions are not deleted. This causes the error 513.
Also if you have call accounting software run a report for no calls over 60 days. Then go from there

Hope this helps
ED

1a2 to ip I seen it all

 

[TheWOneAndOnly]

thx for the reply

"display errors" worked well for 2 times

but suddenly I get the message
"display errors" has a command conflict?
I can use all othe commands except "display errors"???

 

[1a22ip]

I can't reproduce your issue. Have you tried logging off and on?

Thanks
ED

1a2 to ip I seen it all

 

[TheWOneAndOnly]

yes I tried logging off and in again.

PS i created a new thread for this problem.

see:

http://www.tek-tips.com/threadminder.cfm?pid=690&page=1