I have a Adic scalar 218 fiber channel that is running into I/O errors. After stoping and starting nsr services, I was getting errors messages stating that jukebox didn't exsist. I ran jb_config. Configured everything and received the following message:
jb_config: SJI driver not loaded!!! Unable to access device "Standard SJI jukebox on control port scsidev@2.1.0".
(I know the scsidev is correct)
I did a reboot of the server and saw the drivers load at boot time.
again no jukebox found. Ran jb_config and received the same results.
Anyone have any clue. I know that something weird has to happen after boot time if you have a fiber channel.
Any help would be greatly appreciated.
Brett
jb_config: SJI driver not loaded!!! Unable to access device "Standard SJI jukebox on control port scsidev@2.1.0".
(I know the scsidev is correct)
I did a reboot of the server and saw the drivers load at boot time.
again no jukebox found. Ran jb_config and received the same results.
Anyone have any clue. I know that something weird has to happen after boot time if you have a fiber channel.
Any help would be greatly appreciated.
Brett