Leonardost
Technical User
Hi all,
I'm looking for help in configuring CISCO environment.... usually rookie question
We have two routers ( 2600 series, IOS 12.0(7)T ), E1 connected via PRI 2CE1U interface on both sides. The routers are equipped with WIC-2T serial interface cards on both sides. On the first site we have real-time data source (RS232 syncro, HDLC, low speed) and there is a requisite for transfering data onto the other site. Since the sites are already connected via E1, we think it is not necessary to lease new line for this purpose. The idea is to connect source device directly to router interface WIC-2T (DTE-DCE) and receive the data on the other side. We already tried with STUN configuration, but it seems it doesn't work on our router. Didn't find in documentation for this protocol is it supported by this router ( or IOS version ). So please, any help will be appreciated. Thanks.
I'm looking for help in configuring CISCO environment.... usually rookie question
We have two routers ( 2600 series, IOS 12.0(7)T ), E1 connected via PRI 2CE1U interface on both sides. The routers are equipped with WIC-2T serial interface cards on both sides. On the first site we have real-time data source (RS232 syncro, HDLC, low speed) and there is a requisite for transfering data onto the other site. Since the sites are already connected via E1, we think it is not necessary to lease new line for this purpose. The idea is to connect source device directly to router interface WIC-2T (DTE-DCE) and receive the data on the other side. We already tried with STUN configuration, but it seems it doesn't work on our router. Didn't find in documentation for this protocol is it supported by this router ( or IOS version ). So please, any help will be appreciated. Thanks.
