Hi everyone! I need to be able to dig information out of Networker post-backup. Is there any way I can somehow do the following two things through scripts or by digging through the logs?
1. Given a serial number, can I find out which backup group was backed up on it? I know I can find out the save set(s) and the client, but can I find out the group name as well?
2. Given the record of a backup and the tape that it used, can I find out whether the data written to that tape was appended to the tape, or whether it overwrote the data previously on the tape?
Once again I bow to the gurus of the board! Thanks.
Eric
1. Given a serial number, can I find out which backup group was backed up on it? I know I can find out the save set(s) and the client, but can I find out the group name as well?
2. Given the record of a backup and the tape that it used, can I find out whether the data written to that tape was appended to the tape, or whether it overwrote the data previously on the tape?
Once again I bow to the gurus of the board! Thanks.
Eric