Serial Interface

[Glitchen]

I was send this configuration and I cannot get this command to work. Can someone please help?
interface Serial0/0/0:0.575 point-to-point

I get this error
% Invalid input detected at '^' marker.
and the marker is at the 0 after the :

This is on a 2800 seriers router

Thanks in advanced

 

[helpdeskdan]

Wrong serial int command, I believe.

http://www.cisco.com/en/US/products/hw/routers/ps282/products_tech_note09186a008035b051.shtml

 

[plshlpme]

do a
show ip int br

you probably have one to many 0's or something
or maybe forgot to set frame-relay encapsulation on the physical interface?

has the s0/0/0:0 channel group been defined on the controller?

if you can answer all of the above and its still a no go.. then you should post the running config for more help.