Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sending DDI number as cli rather than main bearer number on ISDN2e in UK 1
- Thread starter Jonah29
- Start date
obtsystems
Programmer
Only if it is on the isdn as number and A number sending is enabled on line providers side
- Thread starter
- #3
Hi Obt,
Thank you for the reply. It will be a number on the isdn as the client has just ordered a block of 10 x ddi. They just had the bearer up until now. I have not heard of A number sending before. All I know is I have had some clients where it has worked and some where it hasn’t even though the phone system is capable of it. So should I get the client to check their line provider has A number sending enabled?
Regards
Mark
Thank you for the reply. It will be a number on the isdn as the client has just ordered a block of 10 x ddi. They just had the bearer up until now. I have not heard of A number sending before. All I know is I have had some clients where it has worked and some where it hasn’t even though the phone system is capable of it. So should I get the client to check their line provider has A number sending enabled?
Regards
Mark
-
1
- #4
obtsystems
Programmer
It might work straight away as here EIR will have it enabled by default but Vodafone may not
The format of clip may vary. From last 4 digits to full numbers without the 0. Might have to try a few combinations
The format of clip may vary. From last 4 digits to full numbers without the 0. Might have to try a few combinations
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question