Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sending control codes to projector from powerpoint
- Thread starter ManxDom
- Start date
HalfListener
Programmer
This may sound a little silly, but...
... do you know that the projector accepts commands via the video screen input. Have you read the users manual for the projector? Very few that I have dealt with use this method of control. Perhaps there is a seldom-used remote control for the projector?
I suspect there is more to your question than you posted. Are you asking how to configure your projector via the computer interface? If the projector has a control program and if it is loaded, than you could do some simple (dreaded but simple) 'Sendkey' commands.
... do you know that the projector accepts commands via the video screen input. Have you read the users manual for the projector? Very few that I have dealt with use this method of control. Perhaps there is a seldom-used remote control for the projector?
I suspect there is more to your question than you posted. Are you asking how to configure your projector via the computer interface? If the projector has a control program and if it is loaded, than you could do some simple (dreaded but simple) 'Sendkey' commands.
- Status
Similar threads
- Locked
- Question
- Locked
- Solved
- Locked
- Question
- Locked
- Question