Sending complete IE

[dt2000]

Hi.
How can I put IE "Sending complete" to SETUP or INFO message
ISDN DSS1 signaling.
The result have to be like this "10100001 IE Name Sending complete"
Trunk is TLU76/1.
ver. BC8.0
Thanx

 

[whosrdaddy]

this IE will be send after pressing # on the handset

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[fouesnant]

Hi

You have to set NANLS to indicate what is the min/max number of digit to be send and then set D1=1 in ADC parameter of the dest you are using.
The combination od D1 in ADC plus NANLS will make the system send the ie A1 for Sending complete. Normally as I don't have tested it in BC8 for DSS1

 

[dt2000]

It was the first thing what I did (NANLS min-max, ACD D1=1),but without anny success. I'm going to try #.
Thanx

 

[dt2000]

I tried send # but without any success.
We have problem with too long time (12sec.) between end of dialing "A" and starting to ring "B".
Have you got any idea?

 

[whosrdaddy]

dt2000,

you must understand that you have a rather old software revision PBX, which is not in the latest status. Ask your service provider to upgrade your PBX to latest BC8 version (8.1, CNI-63) maybe this is an issue that already has been solved...

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!