Sending busy tone

[trond456]

I have TSW connected to Alcatel..ISO and GFP are enabled.
the only problem I face is when Alcatel extension calls a busy extension in TSW they can't hear the busy tone, they hear silence.!!when we call a busy extension in Alcatel we can hear the busy extension.
Who is responsible about sending the busy tone??how to control it?? (SIG D1???????)

Also in SEL D3 0-trunk line, 1 is tie line?? any relation to this??
below are the parameters:
the parameter for the route between MX-ONE to alcatel is
<RODAP:ROU=90;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
90 SL60 H'00000350 H'35440000 H'06000000 NO

END

<ROCAP:ROU=90;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
90 7110000000000010 5 2110000000 0 5 128 00151515 211110000031 001100

Any comments??

 

[mundus]

Please printout dest to route 90 and ASPAPARNUM=223;

 

[trond456]

RODDPEST=90;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
1 90 15050000000002501050000010 0 1 0

PARVAL of PARNUM 223=7

 

[bija77]

hi trond456,
did you check the TMU boards?
you can check it by commands
FTMDI:LIM=...;
FTTDI:LIM=...;

 

[trond456]

For sure I Checked all TMUs... it is ok
Any comment

 

[mundus]

Normally you don't have a connection through the network just to give a busy tone, my opinion about it is that Alcatel should sent this busy tone.

 

[bija77]

hi trond456,

How you connected them together? By (Q-sig)……?
Do you have any internally problem in the TSW?
Does the problem occur when you make a call to digital or analogue extension?

regards,