Hi, we have one EBG (Webswitch) attached to a TLU76/1 MD110 BC.10, when I call from EBG to MD110 I see the number but I dón´t see the name, but, if I call from the MD110 to EBG I don´t see the number neither the name. The configuration of the MD110 is the next:
<ROCAP:ROU=94;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
94 013000001000001 5 3110000007 0 30 128 03151515 511110000031 111111
END
<RODAP:ROU=94;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
94 SL60 H'00000310 H'15400000 H'06300000 NO
END
RODDPEST=118;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
118 94 1606100000000250006 0 1 0
END
the configuration of the EBG is QSIG(standar) MMF, enable CRC4, ISDN numbering planing, chanel negotation, use number type for calling number, use number type for called number, use number type for called number, present calling number, send ringing tone.
<ROCAP:ROU=94;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
94 013000001000001 5 3110000007 0 30 128 03151515 511110000031 111111
END
<RODAP:ROU=94;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
94 SL60 H'00000310 H'15400000 H'06300000 NO
END
RODDPEST=118;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
118 94 1606100000000250006 0 1 0
END
the configuration of the EBG is QSIG(standar) MMF, enable CRC4, ISDN numbering planing, chanel negotation, use number type for calling number, use number type for called number, use number type for called number, present calling number, send ringing tone.