WAN IP is 1.1.1.1/28 and the WAN interface is X4.
LAN interface is X0 10.1.50.1/24
There is already a site-to-site VPN for 1.1.1.1 going to an AWS VPC.
I need to setup another site-to-site to another AWS VPC using IP 1.1.1.5.
This VPN should connect and have access to the local LAN (X0)
What zones/address objects/access rules do I need to setup in order for the VPN connection to come UP.
Current VPN settings:
Policy: Tunnel Int
Auth: IKE using PSK
IKE:
Main mode
DH Group 2
Enc: AES-128
Auth: SHA1
Life: 28800
IPSec:
Prot: ESP
Enc: AES-128
Auth: SHA1
PFS: DH Group 2
Life: 3600
I come from the Cisco side and I just can't seem to wrap my head around the Sonicwall GUI.
Are there logs where I can see a connection being attempted? Under the Log link when filtering for the VPN category, it's emtpy. The category is checked under Categories.
LAN interface is X0 10.1.50.1/24
There is already a site-to-site VPN for 1.1.1.1 going to an AWS VPC.
I need to setup another site-to-site to another AWS VPC using IP 1.1.1.5.
This VPN should connect and have access to the local LAN (X0)
What zones/address objects/access rules do I need to setup in order for the VPN connection to come UP.
Current VPN settings:
Policy: Tunnel Int
Auth: IKE using PSK
IKE:
Main mode
DH Group 2
Enc: AES-128
Auth: SHA1
Life: 28800
IPSec:
Prot: ESP
Enc: AES-128
Auth: SHA1
PFS: DH Group 2
Life: 3600
I come from the Cisco side and I just can't seem to wrap my head around the Sonicwall GUI.
Are there logs where I can see a connection being attempted? Under the Log link when filtering for the VPN category, it's emtpy. The category is checked under Categories.