second hand pix... cannot access startup wizard

[promediadawson]

Working with a second hand pix 506e here. i admit my knowledge of things Cisco is a bit sketchy. I have it in my network; I can ping it succesfully, and it shows in my dchp table, but when i try to access the startup wizard from https//192.168.---.---.startup.html, i cannot get through. any ideas? Thanks for reading.

 

[IPKONFIG]

Yes, it's not enabled on the PIX to allow http configuration. Try to console to the device first. I'm assuming that with it being "second hand" that you didn't get it brand new and didn't set it up with the current configuration. Console into it, then you can setup the http access and go from there.

"I can picture a world without war. A world without hate. A world without fear. And I can picture us attacking that world, because they'd never expect it."
- Jack Handey, Deep Thoughts