Using WinXP,Atto dual chan adapter scsi II,Seagate cheetah scsi II 80pin,Icy Dock hot swap tray,adaptec LVD cable.When booting my seagate is being recogbized as a;DEC RZ2ED-LS(C).When I run my Atto tool in DOS I get the following error:
Command Status:0X04 SCSI Error Occured
SCSI Status:0X02 Check Condition
Sense Key:0X03 Medium Error
SEnse Code:0X31 ???
Seagate tools will not recognise this drive,is it possible DEC did a lo level wipe on this drive?Also,the adapter reported NO scsi before I josled the tray a bit could it be a backplane prob?the pins SEEM to be all the way in but I'm not sure.(disk spins up fine,id 0 and adapter id7)I also get Bios not loaded after going thru the adapter load process,I assume this is because of the HD prob?
Command Status:0X04 SCSI Error Occured
SCSI Status:0X02 Check Condition
Sense Key:0X03 Medium Error
SEnse Code:0X31 ???
Seagate tools will not recognise this drive,is it possible DEC did a lo level wipe on this drive?Also,the adapter reported NO scsi before I josled the tray a bit could it be a backplane prob?the pins SEEM to be all the way in but I'm not sure.(disk spins up fine,id 0 and adapter id7)I also get Bios not loaded after going thru the adapter load process,I assume this is because of the HD prob?