SCO UNIX 5.0.7 Drive question

[ccoffice]

Due to circumstances beyond my control, I am now the support for a SCO UNIX box. Can someone please tell me how to find out the cdrom identifier? The client just replaced the cdrom in his box and now it will not run the backup to the drive like it used to.

Thanks in advance!!

 

[PHV]

The client just replaced the cdrom in his box
If the new drive is installed on the same port with same master/slave configuration than the previous drive, then same "identifier": /dev/cd0

What is the output of the hwconfig command ?

Hope This Helps, PH.
FAQ219-2884
FAQ181-2886

 

[ccoffice]

here is the hwconfig output

name=fpu vec=13 dma=- unit=1 type=80387-compatible
name=pci base=0xCF8 offset=0x7 vec=- dma=- am=1 sc=0 buses=5
name=PnP vec=- dma=- nodes=0
name=clock vec=- dma=- type=TSC/2.992500599Ghz
name=serial base=0x3F8 offset=0x7 vec=4 dma=- unit=0 type=Standard nports=1 base
=0 16550A/16
name=console vec=- dma=- unit=vga type=0 num=12 scoansi=1 scroll=50
name=floppy base=0x3F2 offset=0x5 vec=6 dma=2 unit=0 type=135ds18
name=udi vec=- dma=- UDI environment
name=adapter vec=- dma=- ha=0 type=usb_msto UDI SCSI HBA
name=adapter base=0x1F0 offset=0x7 vec=14 dma=- type=IDE ctlr=primary dvr=wd
name=adapter base=0x2400 offset=0xFF vec=9 dma=- type=ad320 ha=0 slot=0 bus=0 id
=7 fts=sto
name=bcme0 vec=10 dma=- chip=BCM5721 mem=DD100000 addr=00:13:21:b4:37:a6
name=epca vec=- dma=- mem=0xDD400000 ports=16 PCI X(e)m V7.0.6
name=cd-rom vec=- dma=- type=IDE unit=0 ctlr=pri cfg=mst dvr=Srom->wd
name=disk vec=- dma=- type=S ha=0 id=0 lun=0 bus=0 ht=ad320 unit=0
name=Sdsk vec=- dma=- cyls=4427 hds=255 secs=63 unit=0 fts=stdb
name=Sdsk-0 vec=- dma=- Vnd=COMPAQ Prd=BF03698578 Rev=HPB2
name=usb_ehci vec=11 dma=- PCI bus=0 dev=29 func=7
name=usb_uhci vec=10 dma=- PCI bus=0 dev=29 func=0
name=usb_uhci vec=5 dma=- PCI bus=0 dev=29 func=1
name=cd-rom vec=- dma=- type=IDE unit=1 ctlr=pri cfg=slv dvr=Srom->wd