First off let me apoligize for my ingornance. I have a SCO 5.0.5 Openserver and a 16-port digibox. I know to use mpi to condigure additional ports on the digibox, but could you tell me step by step how to do this? I just dont want to mess anything else up. You guys are my last line of defense.<br><br>-Dennis
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SCO digiboard
- Thread starter drhixson
- Start date
mpi<br>config<br>select board<br>arrow to port<br>change it<br>esc out<br>can't remember whether it prompts for save.<br>should upgrade your ttytype and enable the port<br> <p>Ed Fair<br><a href=mailto: efair@atlnet.com> efair@atlnet.com</a><br><a href= > </a><br>Any advice I give is my best judgement based on my interpretation of the facts you supply. <br>
Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.<br>
Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.<br>
and after the first page of config use the function key noted to proceed. <p>Ed Fair<br><a href=mailto: efair@atlnet.com> efair@atlnet.com</a><br><a href= > </a><br>Any advice I give is my best judgement based on my interpretation of the facts you supply. <br>
Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.<br>
Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.<br>
- Status