Scheduled jobshows Status as "Device Paused"

[Knersis]

The active back-up job didn't run and shows "Device Paused" in the Status column. How do I activate this job again?

 

[Copierbw]

Try this:

thread481-490703 t helps...

You don't need eyes to see just the vision because there are always more ways and different answers to what we are used to...

 

[Rols]

That post refers to a "SERVER PAUSED" issue.

There are a few different reasons why this could be happening - make sure that the tape device is ok (online). make sure that the target drive pool is not empty - see

http://seer.support.veritas.com/docs/191275.htm

Try unpausing the device - Right click properties of the device --> untick the "enable device" checkbox & click apply --> recheck the "enable device" checkbox & click apply.