I'm trying to figure this out for a while. I'm trying to create an incremental job that runs Monday-Friday at a specify time. The problem is that it will only successfully run once (say Monday). On Tuesday it'll run for about an hour then error stating 'communication error to the remote agent' and it'll continue like this until I delete and recreate the job from scratch. When I recreate the job, it is configure the same way as it was when it ran successfully. So after the job is recreated, it'll run fine for the very first time and error out on its next schedule run. I'm not sure what is going on, besides the files, nothing is changing (ie: hardware, registry).
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Schedule Job Does Not Connect Second Time
- Thread starter scr1b3
- Start date
Similar threads
