SCH6451 1

[Chuck17]

Guys,

I trying to find out how to clear a SCH6451 error message, any help would be greatly appreciated.

 

[cmawbey]

This is a Info only SCH code to inform you that Lampaudit is turned off, this may have been
done for a number of engineering reasons, it can be turned on/off in ld 77
Colin

 

[Chuck17]

I tried to turn on the Lamp audit in LD 77, but everytime I input DLMP, the system outputs '? syntax'. It doesn't allow me to enter 0/1.

 

[cmawbey]

Hmmm.. are you doing it like this

DLMP 0 for on

DLMP 1 for off

if you are entering DLMP 0/1 like this....(that's wrong)

end

Colin

 

[Chuck17]

The system would not let me input anything after DLMP

This is what I entered

DLMP

Then right after I enter the 'DLMP', the system outputs the following: ? SYNTAX



Chuck

 

[cmawbey]

ok
you may well need a higher level password to do this
i do advise that dlmp is turned on, as this affects the clocks on phonesets and also Q931 if you use it...
are you in the UK....????


Colin

 

[Chuck17]

No, I'm in the US...It has come to my attention that a software patch is needed to correct this error. Have you had a problem like this before.



Chuck

 

[cmawbey]

No i have'nt, but i do advise you to turn this function on....


Colin

 

[Chuck17]

I would like to thank Colin, for the the help. A Co-worker of mine contacted tech support and they loaded used a high level password to log into the switch and turn the Lampaudit on.

Thanks for the help

Chuck