Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SCH0011

Status
Not open for further replies.

senk1s

Vendor
Dec 15, 2003
3,606
CA
i'm trying to add a DN ...
in ld 10 dnb, there is no act of this DN
in ludn, it does not show as a free DN

when i try to add this to a key get SCH0011
= TN in DNBLOCK fails TNTRANS

can you guide in this - is it data corruption?
 
Protected or unprotected unit pointers are corrupted. If you have access to PDT and know how to write out corruption you can take care of it. But be very carefull, you can write out too much information. You may also try to reload the PBX. Some times this will clear.

TWM
 
could be. i just tried adding some that would conflict with shorter or longer dn's & it accurately sch codded me

REQ: new
TYPE: 500
TN 16 0 2 14

DN 65555
SCH0371
DN 655
SCH0730
DN 65
SCH0730
 
It is DN corruption! It will need to be written out in debug.
 
thanks workingman, wdhb, phonedoc ...
i'm going to try the univ solution (reboot) and then open a case with nortel
 
i had this issue once and reloaded, had to redo a few program changes i made earlier that day but that was it and all was fine
 
the reboot did fix the problem !! thanks again everyone
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top