Scalar 24 could not be seen by EMC Networker

[Pancevo1956]

I have quantum ADIC Scalar 24.

From two days ago, I have had problem with backup on networker. I suspect my autocharger-jukebox. The reason for that is when I run the following command I have output:

C:\Documents and Settings\Administrator>inquire -l

-l flag found: searching all LUNs, which may take over 10 minutes per adapter
for some fibre channel adapters. Please be patient.

scsidev@0.0.0GC RAID 5 0326|Disk, \\.\PHYSICALDRIVE0
S/N: CK200071900247
WWNN=6006016049AD1C003A826E441E35DC11

PORT=00000001
scsidev@0.1.0GC RAID 5 0326|Disk
scsidev@0.2.0GC RAID 5 0326|Disk
scsidev@0.3.0GC RAID 5 0326|Disk
scsidev@0.4.0:IBM ULTRIUM-TD3 64D0|Tape, \\.\Tape0
S/N: 1210266394
ATNN=IBM ULTRIUM-TD3 12102663
94
WWNN=500308C175E80426
WWPN=500308C175E80427
PORT=00000001
scsidev@4.0.0GC RAID 5 0326|Disk
scsidev@4.1.0GC RAID 5 0326|Disk
scsidev@4.2.0GC RAID 5 0326|Disk
scsidev@4.3.0GC RAID 5 0326|Disk

In fact the NMC ( EMC networker) could not see autochanger.

Ok, I have tested by using LCD and its keys the following:

Status - Fibre Status: Drive 1 No Light
speed N/A
Topol N/A

Drive 2 Connected
speed 4GB/sec
topol L Port

Is that problem? Can I test further to see what the problem is if I swap two Fibre cables on the rear of the jukebox?

 

[Pancevo1956]

Just to add: I have tried to reboot the autochanger by cliking on and off. It is very interesting that it comes with configuration wizards, which I cancelled.

Maybe that tells something has been changed and needs reconfiguration?


I have checked the Status - Errors: I have the following error log over there: SAC 80 7046 (Picker Failed; Clear Picker Status) and SAC E& 7043. I have inspected the tapes and everything seems to be OK. In fact, I could not see whether these messages are in fact from long time ago.
Is there some other procedure to check whether the picker is OK?