SBC Incident/Alarm creation

[skeeter242]

Hi all.

Happy new year.

Does someone know how to create an Incident or Alarm in EMS throug the Cli?
Is there script or a binary to do so?

Thx for reading.

Regards

Sascha

 

[kyle555]

Maybe there's a test alarm in the SNMP configuration. If not, restarting the application should probably send a SNMP cold start event.

Otherwise, any SIP message that doesn't match a flow triggers an incident - like if you have a remote worker SBC facing the internet and you get random SIP calls to international numbers over the internet the SBC refuses to/doesn't know how to route. Probably just sending a register message to the A1 interface will trigger an incident.

 

[skeeter242]

Hi.

Thx.
But that's not what I ment.
I would like to send an Alarm or an Incident messeage through a script.
I'm looking for a command that can be used in a script.

Regards

Sascha