Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SAR deactivation After Rebooting PBX

Status
Not open for further replies.
NTim07

NTim07

Programmer
Jul 3, 2007
12
LB
Hi all,
did anyone face the following problem:

I programmed the SAR Feature where it works fine, but when the PBX Cold Reboot the SAR feature will be deactivated until we set the time with the same value.

IS this a normal behavior or there is some futher active should be taken?

 
Status
Not open for further replies.

Similar threads

BSmith01
  • Locked
  • Question
Nortel PBX Password Change Issue
Replies
6
Views
269
BSmith01
BSmith01
Aklile Tefera
  • Locked
  • Question
CS 1000 PBX
Replies
2
Views
281
Iniesta
Iniesta
VRRyan
  • Locked
  • Question
SS PBX LINK FAILED
Replies
4
Views
173
bignose21
bignose21
MoJHK
  • Locked
  • Question
Busy tone after hangup
Replies
1
Views
115
MoJHK
MoJHK
bltodd
  • Locked
  • Question
ERR008 Digital and Analog Calls in Hang up after initial connection. Calls to outside hangup Fax too
Replies
0
Views
114
bltodd
bltodd

Part and Inventory Search

Sponsor

Back
Top