Samsung 7100 4TRM Card

[KNM398]

I have been able to setup everything EXCEPT the CO line, it is buggering the whole thing up..

When I try the main line (701) "ALL Trunks Out Of Service" OR "BUSY"

I currently have:
1 7100 /w UNI card /w 4SLM & 4TRM cards
1 IP Phone 3201 (working)
1 iDCS 28D 201 (working) P1 MP10a
1 Analog Phone 205 (working) MD1 - P1
1 CO Line (Not working) MD2-P1

Any Ideas would be greatly appreciated ?

PS: I am using the web interface and/or the 28D..

Software Version:
System '11.01.25 V4.53b
MP '11.01.25 V4.53b
SP '10.09.08 V2.52
VMS '10.12.02 V2.80r
MGI '10.05.24 V2.05
BRI NO VERSION DATA
Web '10.04.13 V4.12h
Linux 06.12.23 V2.6.13
MPS '09.05.11 V2.00
MP:
DIP Switch 10000000
EPLD Version V02
PCB Version V02

 

[OldAndKnackered]

Depending on which country you're in, the DIP switches may not be right, usually for the UK it's switch 2 on, and all the rest off. Although I don't know why this would affect your ability to dial out, unless the system was listening for a different dialtone

 

[KNM398]

CatOnKeyboard Thank you for your help.. This unit was pulled by me from a working environment and placed into almost the same environment except only one "1" CO Line.. I tried calling into the CO line but it does not ring through the system.. If I use a test set on the CO line it gives dial tone..

Thanks

 

[OldAndKnackered]

Possibly a faulty port on the line card? do you have any spares?

 

[tmatulja]

Is it really a copper line? I have had problems with Verizon Fios. I had to use a AT&T line balance to get it to work.