Sample Config for 2FXS

[STF26]

Does anyone have any sample configs for a 2FXS?

I would like to do a low budget voip between an Avaya Definity G3si and an Avaya Partner. Here is how I think it would work. On the Definity side, I would connect two analog stations to a Cisco 3725 w/ a 2FXS board. Then on the other side, I would have a 2611 w/ the same board plugged into two line appearances on the Partner. So, when someone picked up one of the two lines on the Partner side, they would hear the dial tone of the stations on the definity side. Now, a person on the partner side would be able to dial any station on the Definity Side. Vice Versa on the Definity side.

Any Suggestions would be much appreciated.

Thanks,

STF

 

[BuckWeet]

If you want to pull dialtone from the definity you need FXOs hooked to analog stations on the definity. then on the partner side, use FXS's and hook it to CO ports..

Also if you're looking for low budget, why are you using a 3725, a 1760 will do this task fine..


BuckWeet

 

[STF26]

Thanks for the info-

We have all of the routers and voice cards already.
So, I figured we could make something work. I found a pretty good article about how to configure the ports however, I was looking for someone who might have done what I want to do already.

Thanks

 

[BuckWeet]

basically what you'll wanna do is "connection plar"

should be tons of info out there on how to do this..

BuckWeet