s8710 Cabinet Size

[4merlucent]

I have checked the documents for the s8710 dimensions (3.4in high x 17.5in wide x 26in deep) and assume that an 800mm x 800mm cabinet will suffice.

However I have been told a special "server" rack is required due to the depth of the s8710 severs

Can anyone confirm if a standard 800mm x 800mm rack is sufficient?

thanks

 

[PhoneTechMan]

Check out this link to Chatsworth. This is the rack I used for my install and it came out great.

http://www.chatsworth.com/catalog/section1/pg20.asp

 

[Dunstan]

Media Server- Avaya S8710 (each) Description Physical Dimensions 3.4h x 26d x 17.5w, 2u (rack units)

The above should answer your question.

Maximum Weight: 60 lb Air Temperature Ambient operating: 50° to 95° F Maximum wet bulb: 82.4° F NOTE: All temperature ratings shown are for sea level. An altitude derating of 1.8° F per 1000 ft to 10000 ft is applicable. No direct sunlight allowed. The internal room temperature must not exceed 104° F Humidity Operating: 10% to 90% Non-operating: 5% to 85% NOTE: Storage maximum humidity of 95% is based on a maximum temperature of 113° F. Altitude maximum for storage corresponds to a pressure minimum of 70kPa. Electrical Input 100-240 VAC, 6A (110V), 50/60 Hz, 600 W (Nominal) BTUs per hour: 2050; Input plug type 5-15P - or Power supply output Rated steady-state power: 400 W Maximum peak power: 400 W Distance between servers ~6 miles (10km) maximum

 

[4merAvaya]

Because of the size and weight Avaya requires a 4-post cabinet to support the server. The S8710 is a Compaq server.

Kevin

 

[4merlucent]

thanks all for your help