Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
s8710/20
- Thread starter testLED
- Start date
short & sweet
1. upgrade your TN or MM firmware
2. upgrade our IPSI (if you have one)
3. backup your translations, and make sure you have a copy OFF the switch. Use FTP and copy it to your PC or a USB flash drive (this is just "in case")
4. build the new license in RFA, if you are doing a major upgrade (CM 3 to Cm4 or Cm5, not needed on minor Cm 3.1.2 to Cm 3.1.4 upgrades)
5. go into the "maint web" page, "manage software"
6. here you can copy the CD, as an "installable image", once youhave the CD image copied, you can then go and install the new image...
It's not that hard, as long as you are prepared. I could find you a 500-700 page document, if you still want, but these are the basics.
mitch
AVAYA Certified Specialist
1. upgrade your TN or MM firmware
2. upgrade our IPSI (if you have one)
3. backup your translations, and make sure you have a copy OFF the switch. Use FTP and copy it to your PC or a USB flash drive (this is just "in case")
4. build the new license in RFA, if you are doing a major upgrade (CM 3 to Cm4 or Cm5, not needed on minor Cm 3.1.2 to Cm 3.1.4 upgrades)
5. go into the "maint web" page, "manage software"
6. here you can copy the CD, as an "installable image", once youhave the CD image copied, you can then go and install the new image...
It's not that hard, as long as you are prepared. I could find you a 500-700 page document, if you still want, but these are the basics.
mitch
AVAYA Certified Specialist
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question