Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

S8400 IP addresses

Status
Not open for further replies.

wmainc

Vendor
Feb 18, 2008
206
US
I'm moving an S8400 (CM5.2) that we have from one room into another, and as a result I need to change the IP addresses in it. The current addresses for the procr are 10.0.2.10 and 10.0.2.11 and I'm trying to change them to 10.0.0.10 & 11. However, when I go through the configure server screen, that errors out and tells me I can't have both interfaces for server1 in the same subnet. Why would it let me before? Could it be that I had the subnet mask set at 255.255.255.0 before (whether that was right or not I don't know) to 255.255.255.128 now (which is correct)?
 
Created a workaround. I had the SIPI and Control Network connections going through the same network switch as the rest of the interfaces. I just took those off and connected them with a cross-over so they could stay on the old addresses and not cause problems.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top