Running DTS from command prompt hangs after completion or failure

[TomKane]

Hi,

I have an issue with running a DTS job from the command line and would be grateful for any advice that you might have. I have a DTS job that calls another DTS job from within it. If I run it in design mode it finishes OK. If I run it from the command line it runs through to the end - the screen says it was sucessful but it doesn't return to the command prompt. Both DTS tasks ar a mixture of connections data pumps and activex scripts. Have you ever heard of this?

Thanks,
Tom

 

[TomKane]

It's sorted out - it's my crazy PC that's at fault - if I run the job from elsewhere it's fine.