rras wizard Network Selection

[Paulreg]

Am I going mad ..
RRAS wizard to add a VPN.
After I choose the Network Interface from the VPN Connection page that is connected to the internet, I expected to get a Network Selection page to choose the Network Interface (to allow VPN clients access to) to appear. It doesn't !
Help ..
Thanks

 

[irbk]

When you see the "select the network interface that is connected to the internet" screen, it IS asking what network interface you want the VPN clients to connect too. I as well am fighting a dual NIC vpn configuration battle at the moment.

 

[Paulreg]

According to what I've read, after the "select the network interface that is connected to the internet" screen, there should be another screen where you choose what network to give vpn users access to.

 

[irbk]

I've not seen that. Only just the 1st screen asking what NIC is connected to the internet and then it asks about DHCP stuff. I've gone through that wizard about 4 dozen times in the past 2 weeks and have not seen that. Then again, I'm just setting up "VPN" not dial up or NAT or anything like that.