routing question

[cmorales]

Cable Modem
Router DLink 614+ (192.168.0.1)
network 192.168.0.0
default gateway 192.168.0.200 (E0)
Connected to Hub
192.168.0.1
192.168.0.2
192.168.0.100
Cisco Router 2500 (E0) 192.168.0.200
network 172.16.0.0
default gateway 172.16.0.1 (E1)
Cisco 1900 switch (default configuration)
172.16.0.2

I finally got pc's from each network to ping opposite nodes. I can even get out from network 192.168.0.0 to the internet.
How do i make it possible to access the internet form network 172.16.0.0

I have ip routing enable (by default)
No RIP
cisco router has an static route.
ip route 0.0.0.0 0.0.0.0 192.168.0.1

I think I have to set up a static route from the DLink router directing everything to the cisco e1 192.168.0.200

If so, how is it done on a DLink router. I can seem to figure it out.

Thans for your time...

Carlos

 

[Twinmoon]

I think you need a default route. A route that if the Dlink doens't know where to route(for ANY packet) it gives it the cisco router.

I'm going under the assumption that you have this set up

[computers] -> [hub] -> [dlink] -> [cisco] -> [internet]

 

[cmorales]

Actually this is the topology:

[computers] -> [hub] -> [cisco] -> [Dlink] -> [internet]

i have a default route on cisco pointing to Dlink:
ip route 0.0.0.0 0.0.0.0 192.168.0.1