Routing mail between 2 Post Offices

[sbford]

I'm working on a client site that has 2 offices connected by a WAN. Each office has a Netware 6.0 server with Groupwise 6. When an email is sent to a user using internet addressing (foo@bar.com), the mail goes to Office 1 and is routed to Office 2.

My problem is this:
I set up a new user in Netware in both offices and gave him a groupwise account on both servers. I can't figure out how to set the POA in his office (Office 2) to receive the mail.

I can send mail internally without a problem, and he can send mail out. I know the other users aren't doing it by using automatic forwarding rules, so I'm not sure how it's set up. Any thoughts? I don't work with Groupwise very much and am a little stuck.

 

[terry712]

he should only have one account

for a wan link scenario like this - i'm assuming it's one nds tree but even if it's two this is still the same

you would have one primary domain , one secondary domain , one gwia , 2 postoffices
all should only use ip to connect to each other

pending on size of sites etc - you may have a nother secondary as it's good practice not to hang anything from the primary and also sometimes nice to hang gwia from something seperate but not allways practical