Routing DID calls thru 400 and on to 3 different 50s

[Stacyjo5]

I have done this before and yet I am drawing a complete blank!
I have a 400 and 3 50s. The DIDs come in to the 400 and need to be distributed to the correct BCM50.
Right now all the 4 digit dialing between the sites is up and running, but I cannot remember how to send the DID calls over. If I rememeber correctly I need to build a Target line in the 400 with the DID digits in the received #, but I don't know how to point that over to the extension on the BCM50.
Any help would be greatly apreciated!
Thanks!!!

 

[Deweyhumbolt]

Under Voip Trunks, you enter the Recd. Digits in the Remote Gateway/Ip Address of the 50.

Adversity is Opportunity

 

[SupportDude]

No target line on the 400.
You use Des Codes to send the call to a route to the appropriate end point BCM.

-SD-

http://www.mysupportguy.net

 

[Stacyjo5]

Thank you for both responses! So do I need to set these up in the Remote Gateway AND in the Desination codes?

 

[SupportDude]

Yup.
Des code puts it on the IP trunks.
Destination Digit match tells the call which IP address to route to.

-SD-

http://www.mysupportguy.net

 

[Stacyjo5]

Thanks so much!

I have another question you might be able to help me with - when I am setting up the BCM50s for centralized voicemail my "instructions" refer to changes in Telco Features but I can't seem to find Telco Features. I know I have seen it before but I can't locate it now. I need to set up the voice message center. Can you help?

Thanks again!!!

 

[Stacyjo5]

Disregard - I found it under applications!

Thanks again!

 

[SupportDude]

Yep.
That's where Voice Message Center is on all the 50's and the 4.0.
Everything will use Message Center 1 by default.
Make sure you set the Target Lines for Vmsg set to get your MWI.


-SD-

http://www.mysupportguy.net