routing and remote access internal network

[zodiaczz]

ok here is my situation.

Server 1 has two network cards. The first card picks up an DHCP address from the external network (Internet) The second card has a 192.168.0.1 address. This server can get on the internet with no problems. I have a second server with 192.168.0.2 as the address and I would like to get on the Internet as well by passing through the first server. I am sure I have done this before using routing and remote access that I would configure on Server 1

Anyone give me a hand?

 

[zodiaczz]

Forget it I figured it out, its just a test lab and used Routing and Remote Access in NAT mode to allow the internet to pass through.

Thanks all